Home > Not Found > Error Loading Vmlinuz-linux Not Found

Error Loading Vmlinuz-linux Not Found


No, I have not seen any alternative to grub2-efi for external booting, but there may be. Try wiping the drive then unplugging and re-plugging the flash drive and trying again. Not 100 percent sure at this point until you manage to display your /dev/sdaX layout, but it is possible that your config is /dev/sda1 rather than /dev/sda2, for example. Step 1: sudo su OR sudo -s then type in your password. Source

Created a stanza in refind.conf: menuentry "CentOS" { Volume CentOS loader \boot\vmlinuz-....x86_64 initrd \boot\initramfs-....x86_64.img options "root=/dev/sda6 ro" } But when I boot rEFInd says: "Starting vmlinuz-...x86_64 / Error: Not Found while Type "df" to see what's mounted where. If everything else fails, you can try a known good workaround by installing the "Run EFI in physical mode" patch for kernel <= 2.6.36 , or patch for kernel >= 2.6.37 OTOH, if you want to have a GRUB installation as a backup, you could re-install it, or copy its files over from /dev/sda8 to /dev/sda2 before you delete /dev/sda8.

Error Unsupported While Loading Vmlinuz

The method I have used to install Antergos to a flash drive is as follows: sudo su cd Downloads (Downloads is where I saved my Antergos ISO) cat antergos.iso > /dev/sdX This one seems to hold your two Fedora GRUBs, so removing it will remove your options #7 and #8. Solution : switch to the other graphic card in MacOS X and reboot.

Recovery is cancelled") 7) Boot EFI\redhat\grub.efi from 199 MiB FAT Volume (if I choose this option I get F17) 8) Boot EFI\fedora\grubx64.efi from 199 MiB FAT Volume (if I choose this My old computer was tire so I bought a Dell Precision 5510 (pretty much an XPS15) which Dell sells preloaded with Unity. Last edited by cfr (2013-03-21 01:00:51) How To Ask Questions The Smart Way | Help VampiresArch Linux | x86_64 | GPT | EFI boot | grub2 | systemd | LVM2 on Error Loading Vmlinuz Unsupported x86_64 UEFI Shell (Beta) x86_64 UEFI Shell (Old) i386 UEFI Shell (Beta) i386 UEFI Shell (Old) Use the Beta Shell.

To be safe, even on non-Mac machines, you can boot the Mac alternate ISO CD, where the UEFI bootloader has been removed. Error Loading Vmlinuz-linux Not Found Arch Try this in ORDER this time if you still want to use the cat command. Replace the X with your proper location for your flashdrive (in my case this was /dev/sdb) Also replace Antergos.iso with the name of your iso. https://sourceforge.net/p/refind/discussion/general/thread/f9464577/ Maybe something is corrupted?

See in particular the "Using EFI Drivers" and "Options for Booting Linux" sections. Error Loading \arch\boot\vmlinuz Not Found The cause of the problem or the reason why it acts as a workaround are unclear. Like 0 C chris.g.ludwig Error loading \arch\boot\vmlinux: Not found Hello all. This can "repair" a broken installation.

Error Loading Vmlinuz-linux Not Found Arch

Sign up for the SourceForge newsletter: I agree to receive quotes, newsletters and other information from sourceforge.net and its partners regarding IT services and products. read this post here There was something wrong with my USB drive. Error Unsupported While Loading Vmlinuz Thanks for pointing me to the right direction. Error Loading Vmlinuz Not Found It looks for the filename EFI/BOOT/bootx64.efi, but Ubuntu provides EFI/BOOT/BOOTX64.EFI.

On Macs use only the Mac alternate ISO CD Setting up GRUB2 (U)EFI Detect (U)EFI firmware processor architecture If you have a non-Mac UEFI system, then you have a x86_64 (aka this contact form Everything went fine (grub2 worked properly and I was able to choose the two OS) but I am allergic to Ubuntu...so I decided to replace it with Fedora. If need be go get a disk and burn it. If you would like continue this conversation please message me in chats so not to clutter the forum. Error File Vmlinuz Not Found

Define the following mappings in grub.cfg in 1.98 : set F1=ctrl-x set F2=ctrl-a set F3=ctrl-eIn grub 1.99, you can use the built-in equivalent already defined : Ctrl-X = F10 Ctrl-C = http://ubuntuforums.org/showthread.php?t=999892 Mac3,1 firmware will not load grub.efi. grub2 efi bootloader Grub2 grub-pc for Apple Fancy menu for GRUB EFI MactelCommunityHelpPages Adv Reply December 14th, 2008 #9 shadowdude1794 View Profile View Forum Posts Private Message A Carafe of http://smartphpstatistics.com/not-found/error-fetching-interface-information-device-not-found-linux.html also, with trying to use dd, it’s very easy.

So, then I can get it to boot without that error. Antergos Vmlinuz Not Found The time now is 12:13 AM. After installing, I turned SATA back on and can now see my second hard drive.

In any event, you should be able to remove one of those two kernel files and still be fine.

To get the BIOS dump, you need to boot into BIOS mode, then use these commands to generate dump files: dd if=/dev/mem of=/boot/vbios.bin bs=65536 skip=12 count=1 dd if=/dev/mem of=/boot/int10.bin bs=4 skip=16 You can do this by storing the kernel (and its initrd) on a FAT partition or by loading an EFI driver for the Linux filesystem you're using. (EFI drivers for ext2fs/ext3fs Selecting the graphic card If your model has 2 graphics card and you wish to completely power down the discrete graphic card in order to save more power, you must add Vmlinuz Not Found Arch For MacBook2,1 a special 'fix_video' hack enabled using intel_agp for intel video chip (945,965) without blacklist. ----------- To work with the efi framebuffer efifb, in grub.cfg we have (example)- linux /vmlinuz

When loading the i915 module it displays an error in dmesg which has probably something to do with the distortion: [ 23.271254] i915 0000:00:02.0: Invalid ROM contents [ 23.272049] [drm:intel_init_bios] *ERROR* Home Technical Issues and Assistance Installation Error loading \arch\boot\vmlinux: Not found This topic has been deleted. Note: After every suspend/resume, the discrete graphic card is powered up again, so you need to disable it through a command line program, which can be executed automatically on each resume Check This Out I’ve had to resort to that myself when I first started trying out new linux distros years ago.

Are you new to LinuxQuestions.org? I could be wrong. DistroUbuntu 9.04 Jaunty Jackalope Re: grub2 EFI boot loader internal/external booting Originally Posted by shadowdude1794 Do you know of anything that might work instead? The former is probably your Fedora 17 copy of GRUB Legacy, but the latter is the name used by Fedora 18's copy of GRUB 2.

Check BIOS/PCI 0000:00:04.1 setup! At this point you can reboot and test it. Must have been from my earlier attempts to write the ISO to the USB. Stickies are not all where, in my opinion, they could/should be.